You should reset your Acurite indoor and outdoor thermometer when the readings start to display incorrect information. When Should I Reset My Acurite Indoor Outdoor Thermometer? If the problem persists even after calibration, consider replacing your batteries with higher mAh ones. Note that if you keep getting bad readings, try recalibrating your device first. Leaving it in the rain is fine, however.Īt this point, you’re ready to read the temperature on your Acurite digital thermometer. Once you’re done setting up your device, make sure that it’s placed in an area where there is no danger of water damage (such as near a pool, sink, or bathroom). This way the screen will light up and you can begin to set it accordingly. If you want to program your Acurite digital thermometer, make sure that it is plugged in. You should also avoid placing it under direct sunlight, which will result in a high-temperature reading. To measure the correct temperature, Don’t forget that nothing is blocking the path between the indoor-outdoor temperature sensor and your thermometer base unit (where you will keep it plugged in).ĭo not plug the base unit right next to the indoor-outdoor temperature sensor, as this may cause a false reading. The indoor-outdoor temperature sensor should ideally be placed as close to the center of the room, as far from the heating and cooling systems as possible. While setting up your Acurite digital thermometer you’ll notice that there are different options for mounting the indoor-outdoor temperature sensor. Where Should I Mount My Indoor-Outdoor Temperature Sensor? Certain models require a lower voltage than others, so if your model requires less voltage than another one it will not activate properly. If you have tried the steps above and didn’t succeed, try to replace the batteries with a brand that has a higher mAh rating. This will let you know that everything is working as it should be now. Once you are finished, press the “MODE” button until your home temperature display appears. Press the “SET” button to put your thermometer back into normal operating mode. If you notice that this new reading still isn’t right, repeat this process. This is your corrected temperature reading and should be correct now. Wait for a single beep to sound, followed by another number flashing on the screen. Once this happens, press the “MODE” button once more and keep it held down.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |